2. Checking the charge
If the battery pack does not charge properly:
• Check the current at the power outlet with another tool. Make sure that the outlet is not turned off.
• Check that the charger contacts have not been shorted by debris or foreign material.
• If the surrounding air temperature is not normal room temperature, move the charger and
battery pack to a location where the temperature is between 45˚F and 104˚F.
3. Charger mounting
• This charger can be installed hanging on a wall
using 2 screws (not supplied).
• Locate the placement for the charger to be wall
mounted.
• If fastening to wood studs, use 2 wood screws.
• Drill two holes on center 4.5 in. apart ensuring that
they are vertically aligned.
• If fastening to drywall, use wall anchors (not
included) and screws to secure the charger to
the wall.
3
OPERATING INSTRUCTIONS
CARE AND MAINTENANCE
Note: If the battery and the charger won’t be used for a
long time, remove the battery from the charger and pull
out the AC power plug.
• Keep the charger clean and clear of debris. Do not allow foreign material to get into the recessed
cavity or onto the contacts. Wipe the charger clean with a dry cloth. Do not use solvents or water,
and do not place the charger in wet conditions.
• Unplug the charger when there is no battery pack in it.
• Fully charge the batteries before placing them in storage.
• The battery pack may be stored in the charger; however, it is recommended to disconnect the
charger from the power source.
•
• Check that the charger contacts have not been shorted by debris or foreign material.
• Recharge the battery pack whenever there is less power. Do not allow the batteries to become
completely discharged.
• Store the charger at normal room temperature. Do not store it in excessive heat. Do not use the
charger in direct sunlight. Recharge at room temperature between 45 and 104˚F (7 and 40˚C). If
the battery pack is hot, allow it to cool down before recharging.
4
To Next Page
Loading...
Need help?
General
