Air Valve Spring
Pattern Control
Knob
Fluid
Control
Knob
Fluid Needle
Spring
Change of Feed Method
This latex spray gun is capable of pressure or
siphon feed. The feed method can be easily
changed by fully turning the side knob. You should
be sure before using the desired feed method.
(See Figure 1)
SPRAY GUN SET-UP
P: Pressure feed
S: Siphon feed
P
S
1
2
Non-Bleeder to Bleeder Conversion
(See Figure 2)
1. Remove spray gun from air supply.
2. Remove fluid control knob and the fluid needle
spring.
3. Remove air valve spring and store it in a safe
place so it can be replaced when necessary to
convert back to a non-bleeder type arrangement.
4. Insert fluid needle spring and replace fluid
control knob.
Before beginning assembly ofproduct, make sure allparts are present. Compare
parts with package contents list. Ifany part is missing ordamaged,do notattemptto
assemble the product. Contactcustomerservice forreplacementparts.
EstimatedAssembly Time:5-10 minutes
Tools Required forAssembly (notincluded):Adjustable wrench
PREPARATION
6
To Next Page
Loading...
Need help?
General
