EasyManuals Logo

Kodak Slide Projector User Manual

Kodak Slide Projector
34 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #30 background imageLoading...
Page #30 background image
26 KODAK CAROUSEL® Slide Projector
Troubleshooting
Consult this guide before calling for service.
PROBLEM CAUSE CORRECTION
Projector does not operate No power to projector Plug power cord into suitable
electrical outlet. Set power
switch to Lamp.
No illumination on screen with slide in
projector gate
Power switch on Off or Fan Set switch to Lamp.
Lamp burned out Install new lamp or lamp module
Lamp not seated in socket Check lamp.
Slide not in proper focus on screen
focus.
Slide itself not sharp Examine slide for proper focus.
First slide in tray not properly focused Focus center of first slide
manually.
Slide in different type of mount from
others
Focus manually.
Projection lens installed improperly Read and follow the instructions
for installing the lens.
Uneven edge-to-edge focus Slide itself is not sharp Examine slide.
Curved field lens used with glass,
plastic, or non-embosssed mounts
Try a flat field lens.
(See “Choosing a Curved- or
Flat-Field Lens” on page 14.)
Curved field lens used for rear
projection
Use a flat field lens.
Lamp performance UInstall new lamp and try again.
Autofocus motor runs continuously Multi-aperture slide or matte-suface
write-on slides in tray
Turn off autofocus.
Autofocus fails to operate Lamp performance Install new lamp and try
autofocus again.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Kodak Slide Projector and is the answer not in the manual?

Kodak Slide Projector Specifications

General IconGeneral
TypeSlide Projector
BrandKodak
Compatibility35mm Slides
Power SourceAC Power
BulbVaries by model (e.g., Tungsten-halogen)

Related product manuals