12
Symptom Possible Cause Solution
No detergent. Spray nozzle in
.edom erusserp-hgih
Detergent suction tube
.dehcatta ylreporp ton
noitcus tnegreted no retliF
.deggolc si ebut
ebut noit
cus tnegreteD
dekcolb ro degamad
.detcurtsbo elzzoN
.ytpme reniatnoc tnegreteD
Adjust the spray nozzle to the
low-pressure position (see page 6).
Check connection.
Run warm water through filter
to remove debris.
Remove obstruction or replace
detergent suction tube.
Clean nozzle (see Page 9).
Replace detergent container.
Pump is noisy. Pump is sucking air. Check that hoses and fittings are airtight.
Turn off machine and purge pump by
squeezing gun trigger until a steady flow
of water emerges through the nozzle.
Water or oil leaking
from bottom of unit.
Check that all fittings are tight.
If excessive leaking occurs,
call Customer Service hotline.
Loose fittings.
A small amount of leakage
is normal.
Excessive leaking may indicate
water seals damaged or worn.
Trigger will not move. Gun safety-lock engaged. Release safety lock.
If you encounter any difficulties not listed above,
please contact the Customer Service hotline.
IMPORTANT: Always follow the Shutdown Instructions (see page 8) before working on
the unit or the accessories. Always discharge residual pressure and turn the engine OFF.
Water leaking Loose fittings. Check that all fittings are tight.
Troubleshooting – continued
Customer Service Hotline:
1-877-888-9572
visit our website:
www.kodiakequipment.ca
To Next Page
Loading...
Need help?
General
