EasyManuals Logo
Home>Kohler>Inverter>13ERG

Kohler 13ERG User Manual

Kohler 13ERG
48 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #24 background imageLoading...
Page #24 background image
12 Scheduled Maintenance TP-6334 9/04
3.3 Lubrication System
3.3.1 Oil Specifications
Use oil that displays the American Petroleum Institute
(API) “Starburst” certification mark for gasoline engines
on the container. Using unsuitable oil or neglecting an
oil change may result in engine damage that is not
covered by the engine warranty. Figure 3-1 shows the
recommended Society of Automotive Engineers (SAE)
viscosity designation for a given operating temperature.
Do not mix different oil brands. Incompatibility could
cause a breakdown of lubricating ingredients and
reduce engine protection.
Model
SAE
Viscosity Grade for
10
/
13
/
15ERG
-- 1 8 _C(0_F) or
above
below
-- 1 8 _C(0_F)
1
0
/
1
3
/
1
5
E
R
10W-30 5W-30
Figure 3-1 Engine Oil Selection
3.3.2 Oil Check
Check the oil level in the crankcase daily or before each
startup to ensure that the level is in the safe range. Do
not check the oil level while operating the unit. Stop the
generator set and keep the generator set level to get an
accurate reading. To check the oil level, remove the
dipstick and wipe the end clean, reinsert and remove.
Maintain the oil level between the Full and Add marks on
the dipstick, as shown in Figure 3-2. See Section 1,
Service Views for the dipstick location.
1
TP-5586-3
2
1. Full mark
2. Add mark
Figure 3-2 Oil Level Check
Note: Do not operate the set if the oil level is below the
Add mark on the dipstick or above the Full mark
on the dipstick.
3.3.3 Oil Additions
Adding some oil between oil changes is normal. The
amount varies with generator set usage. Open the oil fill
cap and pour in a small amount of oil using a funnel or
other suitable pouring device. See Section 1, Service
Views for the oil check and oil fill locations.
3.3.4 Oil Change
Change the oil according to the service schedule or
before generator set storage. Change the oil more
frequently if the generator set operates under dirty,
dusty conditions. Change the oil while the engine is still
warm. See Figure 3-3 for oil capacity. See Section 1,
Service Views for oil fill, oil check, and oil filter locations.
Model L (Qts.)
All models 3.5 (3.7)
Figure 3-3 Oil Capacity (with Filter)

Other manuals for Kohler 13ERG

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Kohler 13ERG and is the answer not in the manual?

Kohler 13ERG Specifications

General IconGeneral
BrandKohler
Model13ERG
CategoryInverter
LanguageEnglish

Related product manuals