TP-6591 10/13 15Section 2 Operation
Rotating the
control knob
to position:
Menu Item
1 Hourmeter/Status
2 Voltage and
Frequency
3 Line 1 to neutral voltage and
Line 2 to neutral voltage
4
Engine temperature (F)
Oil pressure (psi)
5 Battery voltage
RPM
6 Next maintenance interval
7 Software version
8 ECM version
9 Contrast (lighting)
10 Event log
11 Fuel prime
Figure 2-4 Menu Items
Engine Start/Stop Button. The Engine Start/Stop
button toggles the running state of the engine. When the
controller is off, it has no effect. When the controller is in
a low-power mode, the Engine Start/Stop button starts
the engine.
Power Button. The Power button toggles the controller
between on and off. When the controller if off, it does not
respond to any input except the Power button.
LED Status Indicator. The LED provides a summary of
the generator state:
D Green indicates no known problem
D Red indicates one or more faults (i.e. the generator
cannot operate)
D Amber indicates no faults but one or more warnings
(i.e. the generator can operate)
D Slow blink indicates that the generator is not running
D Steady indicates that the generator is running
D Off indicates that the unit is off
Figure 2-5 shows the possible LED displays:
LED
Status Indicator
Power
Button
Engine Condition
Off Off Stopped Any
Slow blink green On Stopped No fault,
No warning
Steady green On Running No fault,
No warning
Slow blink red On Stopped Fault
Steady amber On Running Warning
Slow blink amber On Stopped Warning
Figure 2-5 Possible LED Status Indicator Displays
The controller is factory-set and should not require
configuration or adjustment under normal operating
conditions. If the generator set is reconnected to a
differentvoltage and/or frequency, refer to an authorized
Kohler distributor/dealer for system configuration and
adjustment instructions.
To Next Page
Loading...
Need help?
General
