Faucet Operation
Rotate the handle outward to the open position to start water flow. The handle
LED will illuminate to indicate that the sensor is functioning.
Adjust the handle to the desired water temperature.
Wave your hand under the spout to turn the water OFF.
Wave your hand under the spout again to restart water flow.
NOTE: Some objects that are clear and certain colors are not detectable by the sensor.
Always use your hand for sensor testing.
If needed, refer to the ″Handle LED Adjustment″ section for more information.
NOTE: For extended periods of nonuse, the handle should be returned to the closed
(upright) position. The handle LED will turn OFF, indicating that water flow is not
available.
LED Indicators
Handle LED: Illuminates when the sensor is active.
Circuit board LED: Indicates there is power to the circuit board.
NOTE: The sensor LEDs are only visible inside the spout when the spray hose is
extended.
Green sensor LED: Indicates there is power to the sensor.
Yellow sensor LED: Illuminates when an object has been detected by the sensor.
Features
Automatic shut-off: After four minutes of inactivity, the water will automatically
shut OFF.
Sensor override: In the event of power loss, the sensor function can be bypassed
by turning in the override feature on the solenoid valve. The faucet can then be
operated manually.
Sensor
Open Position
Handle LED
Sensor LEDs
传感器
开启位置
手动控制切换装置
手柄LED灯
传感器各色LED灯
Manual Override
To Next Page
Loading...
Need help?
General
