Required Electrical Service
One dedicated circuit required, protected with Class A Ground-
Fault Circuit-Interrupter (GFCI). Outside North America, this
device may be known as a Residual Current Device (RCD).
Bidet toilet seat: 120 V, 15 A, 60 Hz
Technical Information
All product dimensions are nominal.
Seat shape type: Elongated
Seat front type: Closed-front
Seat-mounting
holes:
5-1/2" (140 mm)
Electrical component
rating:
Bidet toilet seat: 120 V, 15 A, 60 Hz,
1800 W
Power cord length: 43" (1092 mm)
Notes
Install this product according to the installation
guide.
Connect the seat to a cold water supply of
drinking quality water at a pressure of 20 psi -
80 psi (139 kPa - 551 kPa).
Do not install this seat in a location where: (1)
water might be splashed on the product or
(2) excessive moisture, high humidity levels,
or condensation is present. This will avoid
damage to the electronic components.
CAUTION: Risk of property damage. A single
extension cord may be used provided the cord
“Type” begins with “SJ”, 12 gauge, grounded
(12/3), no longer than 25 feet, and plugged into
a GFCI outlet. Promptly replace any extension
cord that exhibits any sign of damage.
To avoid possible product malfunction, do not
plug in the seat until instructed to do so.
Locate the recepticle at least 6" (152 mm)
above the floor, and within a 32" (813 mm)
radius measured 2" (51 mm) from the bowl
ledge.
Kohler Co. reserves the right to make revisions without notice to product specifications.
To Previous Page
Loading...
Need help?
General