Kohler Command CV25 Service Manual

Starter System
24 690 07 Rev. H
KohlerEngines.com
57
Pawls (dogs) Replacement
1. Install a clamp to hold pulley in starter housing and
prevent if from rotating.
2. Remove center screw, washer, and pawl retainer.
3. Note position of pawls and pawl springs before
removing. Remove pawls, pawls springs, brake
spring and brake washer from pulley.
4. Clean/wipe out center pocket of pulley to remove
any accumulated dirt and old lubricant.
5. Apply small amount of grease to new brake washer
and spring, install them in center pocket.
6. Install pawl springs and pawls into pawl slots of
pulley. All parts must be dry.
7. Position drive plate over pawls with actuating ears
down and inside of pawls.
8. Apply a small amount of Loctite
®
271™ to threads of
center screw. Install center screw with washer.
Torque screw to 7.4-8.5 N·m (65-75 in. lb.).
9. Remove clamp and pull starter rope out part way to
check operation of pawls.
Install Starter
1. Install retractable starter onto blower housing leaving
screws slightly loose.
2. Pull starter handle out until pawls engage in drive
cup. Hold handle in this position and tighten screws
securely.

Kohler Command CV25 Specifications

General

Brand	Kohler
Model	Command CV25
Category	Engine
Language	English