Tools and Materials
Thank You For Choosing Kohler Company
We appreciate your commitment to Kohler quality. Please take a few
minutes to review this manual before you start installation. If you
encounter any installation or performance problems, please don’t
hesitate to contact us. Our phone numbers and website are listed on
the back cover. Thanks again for choosing Kohler Company.
Before You Begin
WARNING: Risk of product damage. When using this valve in
a fiberglass or acrylic installation, use the thin wall installation
kit (88526).
CAUTION: Risk of product damage. This valve contains plastic
and rubber components. Do not apply excessive heat to the
valve body when soldering.
CAUTION: Risk of product damage. Do not apply flux or acids
directly to the valve, as damage may result.
CAUTION: Risk of product damage. Do not apply
petroleum-based lubricants to the valve components, as damage
may result.
IMPORTANT! The installer is responsible for installing the valve
and adjusting the maximum water temperature of this valve
according to instructions.
Observe all local plumbing and building codes.
Pipe
Wrench
Adjustable
Wrench
Strap
Wrench
Hacksaw or Tubing Cutter
Propane
Torch
Solder
Hex
Wrench
Thread
Sealant
Plumbers
Putty
Assorted
Screwdrivers
Thermometer
Kohler Co. 3 1012679-2-C
To Next Page
Loading...
Need help?
General
