Installer le mur fini (cont.)
Sceller un espace de 1/8″ (3 mm) entre la surface de la baignoire et le matériau du
mur fini avec du mastic à la silicone colorée. Laisser prendre le mastic selon les
instructions du fabricant.
Instale la pared acabada
Para las instalaciones de sólo bañera
Cepille el polvo y la suciedad del reborde de la bañera.
¡IMPORTANTE! Mantenga una separación de 1/4″ (6 mm) entre la superficie de la
bañera y el filo inferior del material de pared resistente al agua, como se muestra.
Esta separación sirve como una barrera de contacto en caso de el agua llegara a
entrar detrás del sellador de silicona.
Para asegurar que el material de la pared acabada estará a plomo, fije listones de
enrasar arriba del reborde de la bañera y contra los postes de madera, como se
muestra.
Cubra los rebordes de la bañera con material de pared resistente al agua.
Mantenga una separación de 1/4″ (6 mm) entre la superficie de la bañera y el filo
inferior del material de la pared.
Instale el material de la pared acabada sobre el material de pared resistente al
agua. Mantenga una separación de 1/8″ (3 mm) entre el material de la pared
acabada y la superficie de la bañera.
Selle la separación de 1/8″ (3 mm) entre la superficie de la bañera y la pared
acabada con sellador silicona de color. Deje que el sellador se seque según las
instrucciones del fabricante del sellador.
Complete the Installation
CAUTION: Risk of property damage. Make sure that a watertight seal exists
around the drain and overflow.
Connect the drain to the trap according to the drain manufacturer’s instructions.
Install the trim according to the manufacturer’s instructions. Do not install the
showerhead at this time.
Remove the protective covering from the bath.
Open the water supply lines, then run the water to flush out any debris.
Close the valves.
Install the showerhead according to the manufacturer’s instructions.
Check all connections for leaks.
CAUTION: Risk of property damage. If holes have been or must be drilled to
properly install your accessory, we recommend applying 100% silicone sealant
into the drilled holes before securing the accessory to the wall surround to avoid
possible water damage. Follow the accessory manufacturers’ instructions.
Improperly installed accessories could cause leaks and may void the warranty.
If applicable, apply 100% silicone sealant into the previously drilled holes in the
wall surround. Refer to the accessory manufacturer’s instructions to properly
secure the accessory to the wall surround.
If applicable, install all other accessories according to the manufacturer’s
instructions.
If a shower door will be installed, apply 100% silicone sealant in the gap where
the front edges of the end walls meet the bath surface. This will prevent water
from passing through the shower door extrusion to the back side of the wall.
Refer to the shower door manufacturer’s instructions to complete the shower door
installation. Only apply silicone sealant where instructed to do so.
If a shower curtain will be used, ensure the rod is installed above the wall
surrounds.
Sterling 35 1064906-2-A
To Next Page
Loading...
Need help?
General
