FOREWORD INTRODUCTION
1-11
INTRODUCTION 1
This Komatsu machine is designed to be used mainly for the following work:
q Digging work
q Levelling work
q Ditching work
q Loading work
q Demolition work
See the section “RECOMMENDED APPLICATIONS (3-172)“ for further details.
DIRECTIONS OF MACHINE 1
In this manual, the terms front, rear, left, and right refer to the travel direction as seen from the operator's seat
when the operator's seat is facing the front and the sprocket is at the rear of the machine.
OPERATOR PROTECTIVE STRUCTURE
This machine is ROPS compliant to ISO12117-2:2008 when a ROPS plate is installed - see "LOCATION OF
SAFETY LABELS (2-4)" for location of ROPS plate.
VISIBILITY FOR OPERATOR
This machine complies with the visibility standard (ISO 5006).
This machine maintains a close visibility of a height of 1.5 m at a point 1 m away from the outside surface of the
machine and a visibility for a radius of 12 m.
(A) Front (D) Right
(B) Rear (E) Operator's seat
(C) Left (F) Sprocket
To Next Page
Loading...
Need help?
General
