Kramer VM-1H4C Quick Start Guide

VM-1H4C Quick Start
P/N:
2900- 30122 3 QS
Rev:
2
Scan for full manual
VM-1H4C Quick Start Guide
This guide helps you install and use your VM-1H4C for the first time.
Go to www.kramerav.com/downloads/VM-1H4C to download the latest user manual and check if firmware
upgrades are available.
Step 1: Check what’s in the box
VM-1H4C 1:4 HDMI Over CAT5 DA
1 Set of rack ears
Power adapter (12V DC)
1 Power cord
IMPORTANT NOTICE!
We highly recommend using only Kramer UNIKAT cables with these products. If using 3
rd
party shielded CAT-6A cables, both ends of the
shield must be soldered to the connectors for the products to function properly. Do not use any jumpers, unshielded wall plates or mid-
span cable connections. These extenders are not compatible with HDBaseT technologies. Prior to signal extension, ensure that the
extension line cable is lying straight and not coiled.
Step 2: Get to know your VM-1H4C
#
Feature
Function
1
POWER LED
Lights green when the unit receives power
2
REMOTE IR 3.5mm Mini Jack
Connect to the remote IR emitter or receiver
3
INPUT LED
Lights green when the input receives a signal. Flashes when connected but there
is no active signal
4
EDID
READ Button
Press to capture the EDID from the active output
5
SELECT Button
Press to select the output from which to capture the EDID
6
OUTPUT 1~4 LEDs
The relevant LED lights green when that output is connected
7
INPUT HDMI Connector
Connect to the HDMI source
8
RS-232 9-pin D-sub Connector
Connect to an RS-232 controller
9
OUT 1 ~ 4
TP Output RJ-45
Connectors
Connect to the LINE IN RJ-45 connector on the TP receivers
10
12V DC Power Connector
Connect to the +12V DC power adapter. Center pin positive
The terms HDMI, HDMI High-Definition Multimedia Interface, and the HDMI Logo are trademarks or registered trademarks of HDMI Licensing Administrator, Inc.

Kramer VM-1H4C Specifications

General

Brand	Kramer
Model	VM-1H4C
Category	Switch
Language	English