ENEN
Owner’s manualOwner’s manual
14 15
SAFETY INSTRUCTIONS
Installation precautions
• This unit is designed to operate on 10,8 – 14,4 V DC power
supply. If your vehicle does not have this system, a voltage
inverter is required. The device also requires connecting to
negative of the car.
• Choose the mounting location where the unit will not
interfere with the normal driving function of the driver.
Install the unit where it does not get in the driver‘s way and
cannot injure the passenger if there is a sudden stop. DO
NOT install the unit or any cable in a location where:
◦ it may obstruct the steering wheel and gearshift lever
operations,
◦ it may obstruct the operation of safety devices such as air
bags
◦ it may obstruct visibility
◦ there is not enough ventilation provided
• Avoid installing the unit where it would be subject to high
temperature, such as from direct sunlight, hot air, or a
heater, or where it would be subject to dust, dirt or
excessive vibration. Do not expose this equipment to rain
or moisture nor use near strong magnetic elds. Do not
handle this appliance with wet hands.
• Make sure all the connections are executed in a proper
manner. Reversed connection will cause short circuit and
damage.
• Before nally installing the unit, connect the wiring
temporarily and make sure it is all connected up properly
and the unit and the system work properly.
• If the fuse blows, check the power connection and replace
the fuse with one of the same specied rating. If the fuse
blows frequently, consult an authorized service point for
check-up/repair.
• To prevent short circuits, cover the terminals of the
UNUSED leads with insulating tape.
• Make sure that the ignition is o before connecting the
device.
• Make sure to connect the yellow and red power supply
cables after all other cables are already connected.
• The heat sink becomes hot after use. Be careful not to
touch it when removing this unit.
• At the time of installation, be sure to x all wires (wires
both from this unit and from the car itself) in a way that
any wires cannot come into contact with heat sinks on the
rear and side of the unit.
• Installation illustrations show a typical installation. However,
you should make adjustments corresponding to your
specic car. If you have any questions or require information
regarding installation kits, consult your car dealer.
• If you are not sure how to install this unit correctly, have it
installed by a qualied technician. Producer does not claim
liability of incorrect mounting/installation nor for inappropriate
handling and use disregarding this user’s manual.
• When mounting the unit, be sure to use the screws
provided, as instructed. If other screws are used, parts
could become loose or damaged. Use only the parts
included with the unit to ensure proper installation. The
use of unauthorized parts can cause malfunctions.
• When tightening screws or bolts, be careful not to pinch
any connection cord.
• Make sure not to block the ventilation outlets.
• DO NOT connect the speaker leads of the power cord to the
car battery; otherwise, the unit will be seriously damaged.
• BEFORE connecting the speaker leads, check the speaker
wiring in your car.
• Do not remove the housing/disassemble the device. The
device has no user- serviceable parts inside.
• In case of damage, contact an authorized service point for
check-up/repair.
• If the vehicle has been parked for a long time in hot or cold
environment, wait until the temperature in the vehicle
becomes normal before operating the unit. .
Safety instructions
• DO NOT operate this device while driving, as this may lead
to a trac accident.
• Stop the car before performing any operations! Do not
perform any activities that may distract from cautious
To Next Page
Loading...
Need help?
General
