Krups EA8050 User Manual

13
PROBLEMS AND CORRECTIVE ACTIONS
The appliance does not switch on when the
“On/Off” is pressed.
Check that the plug of the power cord is pushed correctly into the mains
socket.
Water or steam comes incorrectly out of the
steam nozzle.
In case of repeated operation, several drops may drip from the steam noz-
zle.
The espresso or coffee is not hot enough. Change the coffee temperature setting.
Heat the cups by rinsing them with hot water.
The coffee is too light or not strong enough.
Check that the coffee bean tank has coffee in it and that it is flowing correctly.
Avoid using oily, caramelised or flavoured coffee.
Reduce the volume of coffee using the central knob.
Turn the grinding fineness knob towards the left for a finer grind.
Prepare in two cycles using the 2 cup function.
The coffee flows too slowly. Turn the grinding fineness knob towards the right for a coarser grind (may
depend on the type of coffee used).
Carry out one or two rinsing cycles.
The coffee is not creamy enough. Turn the grinding fineness knob towards the left for a finer grind (may
depend on the type of coffee used).
Change the Claris cartridge (follow the installation procedure on page 3).
Carry out one or two rinsing cycles.
The appliance does not serve any coffee. An incident has been detected during the preparation. The appliance resets
itself automatically and is then ready for a new cycle.
You have used ground coffee instead of bean
coffee.
Use your vacuum cleaner to suck out the pre-ground coffee in the coffee
bean tank.
The grinder makes a strange noise. There are foreign particles in the grinder.
Contact KRUPS' Customer Service.
The grinding fineness knob is hard to turn. Only change the grinder setting when it is operating.
The steam does not come out of the nozzle. After switching off your appliance and leaving it to cool:
Clean and unblock all of the outlets of the nozzle with the needle supplied
(see page 7). Unblock the outlet of the support pipe of the steam nozzle
with the needle supplied. Remove the Claris cartridge.
There is not enough milk froth. Using the needle supplied unblock the small air inlet at the top of the nozzle
if required.
Use a cold recipient and milk that has been opened recently.
Try changing the type of milk if this does not work (UHT or pasteurised).
The milk froth is too bubbly. Check that the two ends of the small stainless steel tube are fitted correctly
into the flexible part of the steam nozzle.
The Auto-Cappuccino accessory does not suck
the milk (accessory sold separately).
Ensure that the tube immersed in the milk is not blocked.
Check that the flexible tube is fitted correctly into the accessory to avoid air
leaks.
After switching of your appliance and leaving it to cool, unblock the outlet of
the Auto-Cappuccino accessory.
After filling the water tank, the warning mes-
sage is still displayed.
Check that the tank is fitted correctly onto the coffee machine.
Check that the float at the bottom of the tank moves freely.
Rinse the tank and descale if necessary.
The cleaning or descaling programme will not
start.
Unplug the appliance for 20 seconds then switch it back on.
After emptying the used coffee collector, the
warning message is still displayed.
Remove the collector, ensure that it is empty, wait for 6 seconds and fit it
back in place.
Check that the collector is pushed in correctly.
After washing the cleaning drawer, the warning
message is still displayed.
Remove the drawer, wait for 6 seconds and fit it back in place.
Check that the cleaning drawer is pushed in correctly.
The power has been cut off during a cycle. The appliance resets itself automatically when the power is switched back
on and is ready for a new cycle.
There is water or coffee underneath the
appliance.
The drip tray has overflowed: empty it and clean the cleaning drawer.
Check that the drip tray is fitted correctly.
A message “Fault n° XX” appears. Unplug the appliance for 20 seconds, remove the Claris cartridge and if
required, put it back into service.
If the fault persists, note the fault number and contact KRUPS' Customer
Service.
ENGLISH

Krups EA8050 Specifications

General

Brand	Krups
Model	EA8050
Category	Coffee Maker
Language	English