16
Maintenance
All of these options allow you to run the selected programs. You should then follow the on-screen instructions.
Cleaning milk
Provides access to cleaning the machine’s one touch cappuccino block, which is essential
for ensuring good quality milk frothing.
Milk rinsing
Provides access to rinsing the machine’s one touch cappuccino block, which is essential
for ensuring good quality milk frothing.
Coffee rinsing
Provides access to rinsing the machine’s coffee circuit, which ensures the optimum taste
of coffee.
Coffee cleaning
Provides access to cleaning the machine’s coffee circuit (using a cleaning tablet), which
ensures the optimum taste of coffee.
Descaling
Provides access to descaling which is essential for the durability of your machine. When
the number of drinks is not high enough for descaling to be necessary, the function is not
active.
Filter
Provides access to the lter mode, useful if the water is very hard, in order to ensure the
best taste and the health of your machine.
To quit the Cleaning menu, press or the Settings button.
Info
The “Info” menu provides access to information about your use and about certain stages in the life of your machine.
It also informs you about its upkeep. Below are the main details available.
Drinks prepared Displays the number of drinks prepared
Coffee circuit cleaning Indicates that is needs to be completed within x number of cycles.
Descaling Indicates that is needs to be completed within x number of cycles.
Filter Indicates that it will need to be changed in x days or x litres.
To quit the Info menu, press or the Settings button.
GENERAL MAINTENANCE
Emptying the coffee grounds collector and the drip tray
After a certain number of coffees, the machine will ask you to empty the coffee grounds collector and the drip tray.
Not to make correctly these operations can damage your machine.
The drip tray collects used water and the coffee grounds collector collects used ground coffee.
If the message “Please empty the two trays” is displayed, remove, empty and clean the drip collector tray. Remove,
empty and clean the coffee grounds collector (C). Fig. 19.
Replace the coffee grounds collector. Fig. 20
The drip tray is equipped with a oat to indicate when it needs emptying. However, the machine is also programmed
to ask for the drip collector tray to be emptied after a certain number of coffees, in addition to any intermediate
emptying operations that you may complete.
Rinsing the circuits:
You can start rinsing at any time by pressing and selecting Maintenance.
According to the type of recipe prepared, the machine may complete an automatic rinsing when it is turned off.
It is also possible to set an automatic rinse program when it is switched on (see “Settings” section p.22).
To Next Page
Loading...
Need help?
General
