10
CAUTION – PRESSURE
Never open boiler cap (i) or remove filter holder (c) while your
appliance is turned “on” or while there is still pressure in the
boiler container.
To check for pressure:
Turn the selector knob (b) to the “Off” position. Fig. 1.
Turn the selector knob to the steam position (b3) Fig. 10. If steam
comes out of the nozzle, then the boiler chamber is still under
pressure. Close steam knob and proceed with instructions listed
below.
Take a pitcher filled with cold water and hold it underneath the
steam nozzle with nozzle inserted into the pitcher. Then turn the
selector knob to the steam position (b3). Leave steam release
knob open until no more steam comes out of nozzle. When
finished turn the selector knob (b) to the “Off” position.
Now you can remove the boiler cap and the filter holder.
CAUTION – HOT
Do not touch boiler cap (i) during operation. Before removing
boiler cap turn off machine, let it cool down for at least 2 or
3 minutes. Relieve pressure. (See CAUTION-PRESSURE).
Important!
Before using your machine for the first time, or after
not having used it for a considerable amont of time, rinse the
appliance as indicated below. Check that the appliance is
unplugged.
Check that the appliance is unplugged.
Unscrew the boiler cap. Fig. 2.
Pour 8 oz (240 ml) of cold water into the water tank. Do not pour
warm or hot water into the water tank. Fig. 3.
Screw the boiler cap on tightly. Fig. 4.
Fit the filter (without any coffee) into the filter-holder and rotate
filter inside filter-holder to secure it. Fig. 5.
BEFORE FIRST USE
To Next Page
Loading...
Need help?
General
