English
6. INDIVIDUAL PROGRAMMING OF THE VOLUME
OF COFFEE:
To change the pre-programmed amount of water, proceed as follows:
n Fill the water tank and turn the machine on (fig.1, 2, 3 et 4).
n Put a spoonful of coffee in the filter by using a measuring spoon or
use an E.S.E. or soft pod.
n Put the filter holder in place and lock it by turning it to the right as far as
it will go, up to the stop (fig.7).
n Place a cup under the filter holder.
n Hold down the
button (> 3 sec) until the light flashes quickly.
The coffee flows out.
n When the desired amount of espresso is obtained, press the
button. This amount will be saved automatically.
n The next time when you press the button, you will obtain the most
recently recorded amount. Programming for 2 cups uses the same
method, by pressing the button (> 3 sec).
n If you turn off the device, the volumes will need to
be reprogrammed
the next time you use it.
7. MILK FROTHING FUNCTION
n Steam can be used to froth milk by using the steam wand with
frothing nozzle (for example to make a cappuccino or latte).
n As the machine produces steam, the pump will make a thumping
sounds. This sound is normal and is an indication that the machine is
operating properly.
n After using the steam function, the machine purges
automatically to cool down by pumping cold water throug
h the
heating system. During the purging cycles of cold water, the excess
steam in the heating system is released with hot water into the drip
tray.
n The steam and noise that accompany this phase are important
for cooling the machine.
Caution: During and after using the steam wand, the metal
parts of the steam wand can become very hot. Take care
when handling the steam wand to avoid injury.
17
To Next Page
Loading...
Need help?
General
