3 WORK 14
3.12 Refitting the headlight mask with the headlight
602763-10
Main work
–
Connect the electric plug connector
.
602762-11
–
Position the headlight mask and fix it with the rubber band
.
Info
Ensure that the holding lugs engage in the fender.
– Position the brake line and wiring harness. Put on the clamp and mount and
tighten screw
.
Finishing work
– Check the headlight setting. ( p. 14)
3.13 Checking the headlight setting
400726-10
– Position the vehicle upright on a horizontal surface in front of a light wall and make
a mark at the height of the center of the low beam headlight.
–
Make another mark a distance
under the first mark.
Guideline
Distance
5 cm (2 in)
–
Position the vehicle vertically a distance
away from the wall.
Guideline
Distance
5 m (16 ft)
– The rider now sits down on the motorcycle.
– Switch on the low beam.
– Check the headlight setting.
The boundary between light and dark must be exactly on the lower mark for a
motorcycle with driver.
» If the light-dark border does not meet specifications:
– Adjust the headlight range. ( p. 14)
3.14 Adjusting the headlight range
Preparatory work
– Check the headlight setting. ( p. 14)
602764-10
Main work
–
Loosen screw
.
– Adjust the headlight range by swiveling the headlight.
Guideline
The boundary between light and dark must be exactly on the lower mark for a
motorcycle with driver (instructions on how to apply the mark: Checking the
headlight setting).
Info
The headlight range may need to be corrected if luggage is carried on the
vehicle.
To Next Page
Loading...
Need help?
General
