SETUP 2
3
2.1 Transport mode
H02713-01
This vehicle was blocked for transport in the software.
To operate the vehicle, the vehicle electronics must be enabled.
This process is conducted during initial setup in KTM Dealer.net.
Enabling ensures that the initial setup in KTM Dealer.net is docu-
mented.
Enabling can be performed either temporarily, e.g. for a test ride,
or permanently for vehicle handover.
Info
Make sure that the vehicle is permanently enabled before
handing it over to the customer.
2.2 Unpacking and setting up the vehicle
Preliminary work
– Remove the box.
S03261-01
Main work
– Remove the adhesive tape in the upper area of the motorcycle.
S03254-01
– Roll down the film at the sides.
Info
To avoid damaging the motorcycle during unpacking,
leave the other films on the vehicle until you have fin-
ished work on the vehicle.
– Remove the separate enclosure and unpack it. Check that the
scope of supply is complete on the basis of the enclosed pack-
ing list.
Info
The procedure in the event of missing parts is
described in the customer service manual.
– Check the vehicle for transport damage.
Info
The procedure in the event of transport damage is
described in the customer service manual.
To Next Page
Loading...
Need help?
General
