KTM 300 EXC TPI 2019 Setup Instructions

SETUP 2
5
H02537-10
(All EXC models)
– Position the connector retainer and combination instru-
ment on the upper triple clamp.
–
Mount and tighten screws
2
.
Guideline
Remaining screws,
chassis
M6 10 Nm
(7.4 lbf ft)
H02538-10
(All XC‑W models)
– Position the combination instrument on the upper
triple clamp.
–
Mount and tighten screws
2
with the collar bushings.
Guideline
Remaining screws,
chassis
M6 10 Nm
(7.4 lbf ft)
– Route the clutch line with the clutch master cylinder
toward the front between the upper and lower triple
clamps.
– Install the fork legs. ( p. 25)
S01414-10
(All standard EXC/XC-W models)
–
Remove screws
3
and take off handlebar supports.
– Move the handlebar supports to the desired position and
mount and tighten screws
3
.
Guideline
Screw, handle-
bar support
M10 40 Nm (29.5 lbf ft)
Loctite
®
243™
Info
Position the left and right handlebar supports
evenly.
E00483-01
Warning
Danger of accidents A repaired handlebar poses a
safety risk.
If the handlebar is bent or straightened, the mate-
rial becomes fatigued. The handlebar may break
as a result.
– Change the handlebar if the handlebar is dam-
aged or bent.
– Position the handlebar.

KTM 300 EXC TPI 2019 Specifications

General

Displacement	293.2 cm³
Bore x Stroke	72 mm x 72 mm
Starter	Electric starter
Transmission	6-speed
Cooling	Liquid cooled
Rear Suspension	WP XPLOR PDS shock absorber
Seat Height	960 mm
Ground Clearance	370 mm
Fuel Tank Capacity	9.5 liters
Engine Type	2-stroke
Fuel System	Transfer Port Injection (TPI)
Frame	Central double-cradle type 25CrMo4 steel
Front Suspension	WP Xplor 48
Front Brake	Disc brake
Rear Brake	Disc brake 220 mm