EasyManuals Logo
Home>KTM>Motorcycle>65 SX

KTM 65 SX User Manual

KTM 65 SX
91 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #53 background imageLoading...
Page #53 background image
12 BRAKE SYSTEM 51
12.7 Changing the front brake linings x
Warning
Skin irritationBrake fluid can cause skin irritation on contact.
Avoid contact with skin and eyes, and keep out of the reach of children.
Wear suitable protective clothing and goggles.
If brake fluid comes into contact with the eyes, flush the eyes thoroughly with water and consult a physician immediately.
Warning
Danger of accidentsReduced braking efficiency due to old brake fluid.
Change the brake fluid of the front and rear brake according to the service schedule. (Your authorized KTM workshop will
be glad to help.)
Warning
Environmental hazardHazardous substances cause environmental damage.
Oil, grease, filters, fuel, cleaners, brake fluid, etc., should be disposed of as stipulated in applicable regulations.
Info
Never use DOT 5 brake fluid! It is silicone-based and purple in color. Oil seals and brake lines are not designed for DOT 5
brake fluid.
Avoid contact between brake fluid and painted parts. Brake fluid attacks paint!
Use only clean brake fluid from a sealed container.
Preparatory work
Raise the motorcycle with a lift stand. ( p. 27)
Remove the front wheel. x ( p. 58)
Remove the front brake linings. x ( p. 51)
602692-10
Main work
Move the brake fluid reservoir mounted on the handlebar to a horizontal position.
Remove screws 1.
Remove cover 2 with membrane 3.
Press the brake piston back to its basic position and make sure that no brake fluid
overflows from the brake fluid reservoir.
Install the front brake linings. x ( p. 52)
Correct the brake fluid level.
Guideline
Brake fluid level under top level of con-
tainer
5 mm (0.2 in)
Brake fluid DOT 4 / DOT 5.1 ( p. 81)
Position the cover with the membrane. Mount and tighten the screws.
Info
Clean up overflowed or spilt brake fluid immediately with water.
12.8 Removing front brake linings x
Preparatory work
Raise the motorcycle with a lift stand. ( p. 27)
Remove the front wheel. x ( p. 58)
C00033-10
Main work
Remove the lock washer 1.
Remove screw 2.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the KTM 65 SX and is the answer not in the manual?

KTM 65 SX Specifications

General IconGeneral
BrandKTM
Model65 SX
CategoryMotorcycle
LanguageEnglish

Related product manuals