Insert a new oil filter in the engine case, grease the O-rings and mount the oil filter cover
together with the O-ring. Tighten the screws to 6 Nm.
Only use original KTM oil filters. The engine can be damaged if other filters are used.
Mount the oil drain plug with a new seal ring and tighten to 20 Nm.
Unscrew the plug [1]. Add 2 liters (0,53 USgal) of fully-synthetic 10W/60 engine oil accord-
ing to JASO MA quality requirement (e.g. Motorex Cross Power 4T 10W/60) and remount
the plug. Start the engine and allow to run warm in neutral until 5 bars on the temperature
indicator light up. Switch off the engine and check the engine oil level (see "Checking the
engine oil level").
Check the engine for oil leakage.
MAINTENANCE WORK ON CHASSIS AND ENGINE »
68
To Next Page
Loading...
Need help?
General
