3 WORK
10
V01232-10
–
Insert the ignition key in seat lock
1
and turn it clockwise.
– Raise the rear of the passenger seat cover, push it toward the
rear, and remove it upward.
– Remove the ignition key from the seat lock.
3.3 Mounting the passenger seat
Info
The passenger seat cover is also included for the special model.
If it is not required to carry a passenger, the passenger seat cover can be used instead of the passenger
seat.
The passenger seat cover can be fitted in the same way as the passenger seat.
V01233-10
–
Hook holding lugs
1
of the passenger seat onto the storage
compartment, lower the rear and push forward.
– Press the passenger seat downward until it clicks into place.
Warning
Danger of accidents The seat can come loose from the
anchoring if it is not mounted correctly.
– After assembly, check whether the seat is correctly
locked and cannot be pulled up.
– Finally, check that the passenger seat is correctly mounted.
3.4 Charging the 12-V battery
Warning
Risk of injury Battery acid and battery gases cause serious chemical burns.
– Keep 12 V batteries out of the reach of children.
– Wear suitable protective clothing and safety glasses.
– Avoid contact with battery acid and battery gases.
– Keep sparks or open flames away from the 12 V battery.
– Only charge 12 V batteries in well-ventilated rooms.
– Rinse the affected area immediately with plenty of water in the event of contact with the skin.
– Rinse eyes with water for at least 15 minutes and consult a doctor immediately if battery acid and
battery gases get into the eyes.
To Next Page
Loading...
Need help?
General
