Section 1: Assembly & Set-up
Table of Contents
AP-SC4060 & AP-SC4072 Skid Steer Rotary Cutters 326-765MK 12/14/18
8
Front Chain Guards Assembly
Refer to Figure 1-1:
DANGER
!
To avoid serious injury or death:
Rotary Cutters have the ability to discharge objects at high
speeds; therefore, the use of front and rear safety guards is
mandatory with this cutter. Stop blade rotation if a bystander
is in or around the area.
1. Install front chain guard (#1) as shown with four
3/8"-16X1 1/4" bolts (#4).
2. Insert 3/8"-16X1 1/4" bolts (#4) through chain guard
(#1) and through the cutter’s front bar (#2).
3. Secure 3/8"-16X1 1/4" bolts (#4) with four flanged
locknuts (#5)
4. Repeat steps 1 through 3 for chain guard (#3)
5. Tighten nuts to correct torque.
SC4060 & SC4072 Front Chain Guard Assembly
Figure 1-1
39983
To Next Page
Loading...
Need help?
General
