Kubota GL9000-STD User Manual

12 CONNECTING THE LOAD
ENGLISH
CONNECTING THE LOAD
B Connection Notes
WARNING
To avoid personal injury:
A Before the generator can be
connected to a building’s electrical
system, a licensed electrician must
install an isolation (transfer) switch
in the building’s main fuse box. The
switch is the connection point for
generator power and allows
selection of generator or main line
power to the building. This will
prevent the generator from charging
the main power line (backfeeding)
when the main power supply has
failed or has been turned off for line
repair. Backfeeding can electrocute
or injure line maintenance
personnel. Also, generator and
building electrical system damage
can occur when normal operating
power returns if unit is used without
an isolation switch.
1. Avoid connecting the generator to commercial
power outlet.
2. Avoid connecting the generator in parallel with any
other generator.
B Connecting the Load (Terminal output
Model)
WARNING
To avoid personal injury:
A Connect or disconnect the load to
the AC receptacles or terminals only
when the engine is stopped.
A For your safety, close the terminal
cover after connecting the load.
A For your safety, secure the cover
with the lock bolts.
1. Turn OFF the circuit breaker on the control panel.
2. Connect the load to the A.C. output terminals.
3. Be sure to close the terminal cover after connecting
the load.
(1) Circuit breaker
(2) Terminals (output)
(3) Cover lock bolt

Kubota GL9000-STD Specifications

General

Brand	Kubota
Model	GL9000-STD
Category	Portable Generator
Language	English