25OPERATING THE GENERATOR
ENGLISH
BStopping the Engine
1. Turn OFF all electrical device switches
for connected loads.
2. Turn OFF the circuit breakers.
3. Allow the engine to run with no load for
about 5 minutes before stopping the
engine completely.
4. Turn the main switch (key) to the "OFF"
position.
5. Turn the fuel lever to the "CLOSE"
position.
BIf the Engine Fails to Stop in the Usual
Procedure (EMERGENCY STOP)
If the engine does not stop after turning the key switch to
"OFF" position, take the following (emergency stop)
procedure.
To avoid personal injury:
A Keep your hands away from the
rotating parts, such as cooling fan
and V-belt. Otherwise personal injury
may be caused when manipulating
the engine stop lever.
1. Open the door, using the door knob.
2. Turn the engine stop lever to "STOP" direction and
hold it for 5 to 10 seconds to shut off the engine.
[Engine model : Z482, D722]
[Engine model : D1005, V1305]
(1) Main switch (Key) (A) "OFF"
(1) Fuel lever
(2) Filter bowl
(A) "CLOSE"
(1) Engine stop lever (A) "START"
(B) "STOP"
To Next Page
Loading...
Need help?
General
