C. MACHINE SPECS; continued …
LOADER;
Lift capacity to max. height at bucket bottom midpoint; 2,200 lbs., Lift capacity to max. height at pivot pin;
2,848 lbs., Breakout force at pivot pin; 4,530 lbs., Net weight; (approximately) 1,040 lbs. Auto-Leveling
Mechanism; standard, hydraulic.
OPERATING DISTANCES;
A. Maximum lift height to pivot pin; 113.9”
B. Clearance with bucket dumped; 90.0”
C. Reach at maximum height; 16.8”
D. Maximum Dump Angle; 44 degrees
E. Reach with bucket on ground; 68.5”
F. Bucket rollback angler; 48 degrees
G. Digging depth; 3.5”
H. Overall height in carrying position; 55.2”
PERFORMANCE RATINGS (No Load); on off
Raises to full height; 3.6 sec. 3.2 sec.
Lowering time self level valve; 5.8 sec. 3.5 sec.
Attachment rollback time; 1.9 sec. 1.9 sec.
Attachment dumping time; 2.2 sec. 2.2 sec.
OPERATIONAL DATA; Digging Depth; 18’ 2.7”, Overall Reach; 21’ 8” (Swing Pivot), Loading Height; 14’ 1.3”, Loading
Reach; (Dipper Retracted) 9’ 3.9”, Swing Arc; 180 degrees, Stabilizer Spread; 9’9”, Digging Force; (Bucket Cylinder)
11,334 lbf, (Dipper Cylinder); 4,887 lbf., Leveling Angle; 13.8 degrees. Lift Capacity (with general purpose bucket)
6,803 lbs., Dump Angle at Full Height; 47 degrees. Digging Depth Below Grade with bucket flat; 6.1”.
INSTRUMENTATION; Gauges; Engine Water Temperature, Converter Oil Temperature, Fuel Level, Tachometer /
Hourmeter and Voltmeter. Warning Lights; Air Cleaner Restriction, Alternator, A/C High Pressure, Cols Start, Engine
Oil Pressure Low, Hydraulic Oil Filter Bypass, Parking Brake Engagement and Low Fuel. Audible Position and
Backup. Horn; Dual Switch, front and rear.
ENGINE; (see specifications; page 9-2), Case model; #445T/M3, Type; 4-Stroke, Turbo-Charged, Cylinders; 4, Fuel
Injected; Direct, Fuel Filter; with Water Trap, Air Intake; Cross Flow, Engine Speed(RPM’S); Rated Speed; 2200,
Low Idle; 875 - 1025, High Idle; No Load; 2300 - 2450. Horsepower; (Gross) 85 @ 2200 rpms. Maximum Torque @
1400 rpms; 276 lb-ft (374 N-m)
POWERTRAIN; (see specifications; page 9-4), 4F-4R Power Shuttle Synchromesh Transmission Manual Gear Shift
Fully Synchronized. Travel Speeds; MPH - Forward; (1
st
) 3.8, (2
nd
) 6.1, (3
rd
); 12.9, (4
th
); 24.3, Reverse; (1
st
) 4.5,
(2
nd
) 7.3, (3
rd
); 15.5, (4
th
); 29.1.
SERVICE & PARKING BRAKES; ( see specifications, page 9-5), Individually Applied, Power Assisted, Hydraulically
Actuated, Maintenance-Free, Self-Adjusting, Outboard Mounted, Wet Disc, 2-Per Side. Parking Brake; Trans Mounted
Spring Applied Hydraulic Released.
ELECTRICAL; Voltage; 12-Volt, Negative Ground. Alternator; 120-Amps, Battery; 850 Cold-Cranking Amps.
FLUID CAPACITIES; Engine Crank Case (with filter change); 13.6-quarts, Fuel Tank; 42-gallons, Cooling System
(50% water and 50% ethylene glycol); 16.1-quarts, Hydraulic System (with extend-a-hoe); 118.0-quarts.,
Transmission (four-wheel drive); total system; 21-quarts, (with or without filter change); 14-quarts, Front Drive Axle
(four-wheel drive); 8.1-quarts, Rear Axle (Differential); 14.4-quarts. Front Planetary Hub; .05-qts. of 80W140 Gear Lub.
HYDRAULICS; (see specifications; page 9-6), Standard Main Relief Pressure; 3350+/- 50 psi@ 28.5-gpm.
SOUND LEVELS; (see specifications; 9-26) with engine at 2200 rpms;78 dB(A).
DIMENSIONS & WEIGHT;
TRACTOR; (see specifications of the Tractor; page 2-3)
Overall Length (without 3P, with front guard); 116.1”, Overall Width; 72.5”, Overall Height with ROPS; 95.1”,
Wheel Base; 72.5”, Minimum Ground Clearance; 14.4 at transmission case), Tread; front; 45.9”, rear; 56.1”.
Weight; 4,308 lbs. (Tractor). Approximate Weights; (Tractor; 4,308 lbs., Loader; 960 lbs. and Backhoe;
Total weight of the Tractor, Loader, Backhoe; 7,713 lbs. Loader Bucket Sizes; 82” width, Capacities; .87-Cubic
Yards (Struck), 1.03-Cubic Yards (Heaped), Loader Bucket Weight; 683 lbs.
Approximate Operating heights; (using a general purpose bucket), fully raised (with 19.5L x 25 rear tires); 164.7”.
Height to bucket hinge pin, fully raised; 134.5”. Overall Height, travel position (with extend-a-hoe); 139.2”.
Overall length with bucket on the ground; 280.3”. Dump Angle at full height; 47 degrees, Dump Height at
45 degree dump; 105.9”. Dump Reach at 45 degree dump; 31.5”. Roll Back at Ground Level; 42 degrees,
Wheelbase; 84.0”. Overall Width (rear tires); 81.8”.
BACKHOE; Bucket Size; (choice of cutting widths) 18”; Bucket Weights; 356.3 lbs., or 24”: 426.6 lbs.
TIRES; Size; (front) 12 x 16.5, (rear) 19.5L - 24. Maximum (COLD) Air Pressure; (front); 28 psi, (rear); 50 psi.
OPERATING WEIGHTS; approximately machine weight; 15,132 lbs.
D. WARNINGS; Read these instructions thoroughly. Failure to follow instructions could cause a malfunction of the machine
and result in death or serious bodily injury and / or property damage. Do not use this equipment until you have;
(1.) been instructed by a “uniformed TRC” employee on the machine’s safe operation (2.) you have located the
manufacturer’s operator’s manual (located on the backside of the operator’s seat), in a clear enclosure. 3.) you have
taken the Manufacturer’s Operator’s Manual out of the storage enclosure and have read, reviewed and fully understand
it’s contents. This includes the (a.) the manufacturer’s operating manual (b.) any AEM safety manuals (c.) all safety
decals on the machine, also (3.) the operator understands the manufacturer’s intended safe use safe operation of
this equipment. The operator’s manual must stay close by to the machine. It should always be available for the use
of the operator at all times. After reading and reviewing this information, please place the booklet (s) back in the sealed
sleeve, before re-inserting back in the clear enclosure). Do not use this equipment without the operator’s manual being
2015 - KUBOTA #L45 “TRACTOR / LOADER / BACKHOE” - OPERATIONAL and SAFETY INSTRUCTIONS page 2 - 6
To Next Page
Loading...
Need help?
General
