QUICK-START SETUP INSTRUCTIONS
Making Connections:
• Connect 1/4” non-shielded speaker cables to the speaker out jacks on the rear
of the KPM7250T (29 & 30), then connect the opposite end of each speaker
cable to the speaker enclosures.
• Connect instruments and microphones into the appropriate input connectors
located on the front of the mixer. Low Impedance Microphones (6), Line Level
(5), High Impedance Instruments (7 & 8), tape/CD (25).
•Μake sure the power switch is turned to the off position and attach the AC
power cable into the fused AC input (27) located on the rear of the mixer.
Master Section:
•Τurn the Main Master control (20), and Playback Master (24) counter clockwise.
•Αdjust the master equalizer slide controls (19) to the center 0dB position.
Input Section:
•Τurn all channel volume controls (4) counter clockwise.
• Turn all tone controls (3) to the 12 O’clock position.
6
To Next Page
Loading...
Need help?
General
