Name: KYMCO Vitality 50
Brand: KYMCO
Rating: 4 (1 reviews)

To Next Page

To Previous Page

ENGINE OIL CHANGE (4-STOKE)

2. Remove the oil filter cap/dipstick (1).

3. Remove the drain bolt (2) to drain the oil.

4. Install the drain bolt and tighten it. (Torque: 30 Nm)

5. Refill 0.7 litres of fresh engine oil. Firmly tighten the oil dispstick.

6. Warm up the engine and check the oil level again after is stopped

for 30 – 40 seconds.

• Specified oil: SAE10W40

• Capacity / Refilling Capacity: 0.85L / 0.7L

• When changing the engine oil, also clean the oil strainer

and reinstall it.

hang

areas

- 50 -

Place the scooter on its centre stand on level ground.

• Use the specified engine oil.

en c

• Change the engine oil after the first 300km and th e

it at every 2000km.

• Engine oil will deteriorate easily and require mo

frequent change if the scooter is ridden often in dusty

or cold climates or if it is ridden only for short distances.

• Do not mix engine oil of different classes or viscosities. It

the engine.

may cause damage to

Other manuals for KYMCO Vitality 50

Questions and Answers:

Need help?

Do you have a question about the KYMCO Vitality 50 and is the answer not in the manual?

General