Settings Pages
Specifies a name for the printing system network component. This name is
also used as the NetBEUI printer name and WSD device name.
Dynamic DNS
When an IP address that was mapped by the DNS server has been
changed, Dynamic DNS automatically remaps the host name to the IP
adress.
IPv4 Settings
• DHCP/BOOTP
Specifies whether or not to automatically obtain an IP address using DHCP or
BOOTP.
• Auto-IP
Turn On to automatically assign a unique IP address even though a DHCP
server does not exist or DHCP setting is Off in the printing system. The range
of the IP address to be assigned is from 169.254.0.0 to 169.254.255.255,
which is reserved for Auto-IP. If an IP address is already assigned by a
DHCP server, this does not resolve a new IP address.
• IP Address
If DHCP = OFF, then a static IPv4 address can be entered in this field as part
of the system network settings. If DHCP = ON, then a dynamic IPv4 address
is assigned to the device, and the field is grayed out. The format of the IPv4
address is a sequence of numbers separated by dots. For
example: 192.168.110.171
• Subnet Mask
Specifies the subnet mask.
• Default Gateway
Specifies the IP address of the default gateway.
• Domain Name
Specifies the DNS (Domain Name System) name of the domain to which the
printing system belongs. It should not contain the host printer name, for
example, "abcde.com".
• DNS Server (Primary, Secondary)
Specifies the IP addresses of the primary and secondary DNS (Domain
Name System) servers. When DHCP/BOOTP is turned On, you can select to
use the DNS server obtained via DHCP, or you can enter static DNS server
information in the Primary and Secondary fields provided.
• WINS Server (Primary, Secondary)
Specifies the IP addresses of the primary and secondary WINS (Windows
Internet Name Service) servers. When DHCP/BOOTP is turned On, you can
select to use the WINS server obtained via DHCP, or you can enter static
WINS server information in the Primary and Secondary fields provided.
• Bonjour
This section enables/disables Bonjour Protocol.
You can add a Bonjour-enabled printer in Mac OS X using the Printer Setup
Utility. The procedure varies slightly between Mac OS X versions. Bonjour
print is also available in Windows OS using "Bonjour Print Services for
Windows". With this tool installed on the Windows PC, a Bonjour-enabled
printer can be installed using the "Bonjour Printer Wizard."
To allow printing from the Mac OS X system, the printer needs to support
KPDL.
COMMAND CENTER RX 6-33
To Next Page
Loading...
Need help?
General