2-27
Installing and Setting up the Machine > Energy Saver function
Sleep Level (Energy Saver and Quick Recovery) (models except for Europe)
For sleep level, you can toggle between the following two modes: Energy Saver mode and Quick Recovery mode. The
default setting is Energy Saver mode.
Energy Saver mode reduces power consumption even more than Quick Recovery mode, and allows Sleep Mode to be
set se
parately for each function. The ID card cannot be recognized.
Follow the steps below to select the sleep level and use Energy Saver mode for each function.
1
Display the screen.
[Menu] key > [▲] [] key > [Device Common] > [OK] key > [▲] [] key > [Timer Setting] >
[OK] key > [▲] [] key > [Slee
p Level Set.] > [OK] key > [▲] [] key > [Sleep Level] >
[OK] k
ey
2
Select the Sleep level.
[▲] [] key > [Quick Recovery] or [Energy Saver] > [OK] key
When [Energ
y Saver] is set, next go on to set whether or not to use Energy Saver mode for
each function.
3
Set the Sleep rule.
1 [▲] [] key > [Status] > [OK] key
2 Select
the function to be set, and select the [OK] key.
[Card Reader] is displayed when the optional Card Authentication Kit is activated.
3 [▲] [] key > [Off] or [On] > [OK] key
Repeat steps 3-2 to 3-3 to set for a different function.
Power Off Rule (models for Europe)
The Power Off Rule is used to stop the power from automatically turning off.
The default preset time is 3 days.
For more information on Power Off Rule sett
ings, refer to the following:
Power Off Rule (models for Europe) (page 8-32)
If the optional Network Interface Kit is installed, this function will not be displayed.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
