3
Plug in & Switch on
Before plugging in your Labcold freezer for the rst time make sure the power cable is free from
damage and check that your voltage corresponds to that on the serial plate.
It is recommended that you do not use extension cords or multiple socket adapters. Make sure
the power cable is not bent, pinched or compressed and that it can be easily accessed.
If necessary push and hold the button for 3 seconds (approx) to start the freezer
ALTHOUGH THE FREEZER WILL REACH -20°C AFTER A FEW HOURS (APPROX) YOU SHOULD
LEAVE THE FREEZER RUNNING FOR 24 HOURS BEFORE FILLING WITH TEMPERATURE
SENSITIVE PRODUCTS.
Front Panel Display
Manual Defrost
button with defrost
LED
Press to view the
set point
Air temperature
inside the freezer
Your freezer is preset to -20°C so you do not have to program the set point. To check the set
point, simply press the button.
If the compressor LED is on, the compressor is on. This is a normal part of operation especially
after door openings. If the LED is red, the freezer is either in standby mode or is off . In either
of these states it will not be cooling. Press and hold the off /on button to restart the freezer.
THE FREEZER HAS A PRE PROGRAMED SET POINT OF -20°C
ONLY A LABCOLD ENGINEER CAN CHANGE THE SET POINT.
If necessary push and hold the button for 3 seconds (approx) to start the freezer
Off /On button
Compressor LED
point, simply press the button.
after door openings. If the LED is red, the freezer is either in standby mode or is off . In either
To Next Page
Loading...
Need help?
General
