ClimaPilot
05
65
ClimaPilot
MODE
MIN/MAX
MAX MIN
°F °C RH
%
1 2 3 4
Function / Application
The device is used to measure relative humidity and ambient
temperature and to display the calculated dew point. Humidity
and temperatures are measured by means of high-speed sensors
integrated in the tip of the probe. Thanks to its low power con-
sumption, the device can also be used for long-term measurements.
The integrated min/max function allows the lowest and highest
measured values to be shown.
Sensor
LC display
Toggle measurement
in °C / °F
Toggle temperature /
dew point display
1
2
3
Switch on MAX/MIN values
On/off button (rear)
Battery compartment
(rear)
4
5
6
Completely read through the operating instructions, the
„Warranty and Additional Information“ booklet as well as
the latest information under the internet link at the end
of these instructions. Follow the instructions they contain.
This document must be kept in a safe place and passed on
together with the device.
!
Safety instructions
Dealing with electromagnetic radiation
– The measuring device complies with electromagnetic compatibility
regulations and limit values in accordance with EMC-Directive
2014/30/EU.
– Local operating restrictions – for example, in hospitals, aircraft, petrol
stations or in the vicinity of people with pacemakers – may apply.
Electronic devices can potentially cause hazards or interference or be
subject to hazards or interference.
General safety instructions
– The device must only be used in accordance with its intended
purpose and within the scope of the specications.
– The structure of the device must not be modied in any way.
– Do not expose the device to mechanical stress, extreme
temperatures or signicant vibration
EN
To Next Page
Loading...
Need help?
General
