Page 3
2. Health and Safety Cont.
• Always contact Lavazza Professional Customer Service department or
visit www.lavazzapro.co.uk in the event of a breakdown or fault. Under
no circumstances should you attempt to service or repair this machine.
• A KLIX
®
machine power supply unit incorporates IEC power sockets
to provide mains power to the heater, chiller and approved systems
within the KLIX
®
machine. These sockets have been designed for this
purpose only. The use of these sockets to provide electrical power
to any other equipment may result in a hazardous condition and is
therefore prohibited. Contact Lavazza Professional Customer Service
for additional advice.
• Always contact Lavazza Professional Customer Service department or
visit www.lavazzapro.co.uk if you need to move the machine.
• Never attempt to use or replace a damaged cord set. If your cord set is
damaged, isolate the electrical supply and contact Lavazza Professional
Customer Service department immediately.
• Never power the machine using extension cables.
• This machine must not be cleaned using a pressurised water system.
• This machine must not be installed near a pressurised water system.
• Always ensure the machine is installed on a level surface. Failure to do
so could result in injury or damage to machine.
• New hose sets supplied with this machine must be installed and old
hose sets must be disposed of. Only approved Lavazza Professional
hose set can be used if replacement is required.
• Never attempt to adjust the water volume or water temperature. Factory
settings must be maintained at all times.
• Do not reinsert cups into the vend area after a vend has been completed.
• Always check the top of the door for loose objects before opening.
• Never load damaged cups into the machine and ensure correct cup
sizes have been loaded into each stack. It is recommended to only use
KLIX
®
branded cups.
• Extra care must be taken when removing and transporting hot beverages.
Not observing these precautions may result in injury to person.
To Next Page
Loading...
Need help?
General
