LeapFrog Channel Fun Learning Remote User Manual

4
INSTRUCTIONS
Battery Removal and Installation
1. Make sure the unit is turned Off.
2. Find the battery cover located on the bottom of the unit, use
a screwdriver to loosen the screw and then open the battery
cover.
3. Remove old battery by pulling up on one end of the battery.
4. Install 2 new AAA (AM-4/LR03) battery following the
diagram inside the battery box. (For best performance,
alkaline batteries or fully charged Ni-MH rechargeable
batteries are recommended.)
5. Replace the battery cover and tighten the screw to secure.
WARNING:
Adult assembly required for battery installation.
Keep batteries out of reach of children.
ATTENTION :
Les piles ou accumulateurs doivent être installés par un adulte.
Tenir les piles ou accumulateurs hors de portée des enfants.

LeapFrog Channel Fun Learning Remote Specifications

General

Brand	LeapFrog
Model	Channel Fun Learning Remote
Category	Toy
Language	English