Learning Resources Magnetic Time Tracker User Manual

seconds (ENTER). Note: the yellow alert light cannot be set for longer than
the green light.
5. The word Sound will appear on the screen. Press ENTER. Then, use the UP/
DOWN buttons to select Yes or No (Y/N). Press ENTER.
6. To start the timer, press ENTER again. The green light will go on.
7. If selected, the yellow alert light will light up and an alarm will sound at the
programmed time. There will always be an audible countdown for the last 5
seconds.
8. The RED light will flash when time is up.
9. The timer will remain as programmed until you reset it, even if the power is
turned off.
10. To restart the timer, press the POWER button. Then, select TIMER (ENTER)
and START (ENTER). The time will appear on the screen. Press ENTER again
to start the timer.
VOLUME
To adjust the volume at any time, press the UP/DOWN buttons (UP to increase the
volume, and DOWN to lower the volume).
Use the Magnetic Time Tracker on most magnetic surfaces, hang it on a wall, or
activate the flip-out stand to set it on a desk or tabletop. Be sure to check that the
unit is secure before use.
If the Magnetic Time Tracker malfunctions or is not operating properly, please use
a paperclip or pen tip to gently depress the recessed RESET switch on the back of
the unit.

Learning Resources Magnetic Time Tracker Specifications

General

Brand	Learning Resources
Model	Magnetic Time Tracker
Category	Timer
Language	English