LeCroy Waverunner2 Series User Manual

2-4 General Information
Power On
Connect the oscilloscope to the power outlet and switch it on using the power
On/Standby button, located near the left-hand corner of the instrument below the
screen. After the instrument is switched on, auto-calibration is performed and a test
of the disk drive analyzer's ADCs and memories is carried out. The full testing
procedure takes approximately 10 seconds, after which time a display will appear on
the screen.

LeCroy Waverunner2 Series Specifications

General

Brand	LeCroy
Model	Waverunner2 Series
Category	Test Equipment
Language	English