Pedals
1. To unfold the pedals push down slightly and move the pedal outwards.
2. Continue pushing down while lowering it into its unfolded position.
3. Ensure you hear the pedal lock into place once in the unfolded position.
Preparing to Ride
● Ensure all components are properly secured before riding otherwise serious harm
or death could occur. This includes but is not limited to: pedals, handlebars,
handlebar clamp, cranks, seat, and seatpost clamp.
● Make sure you can’t twist the seat or stem out of alignment by hand.
● Check to see if your saddle is positioned at the proper height. Sit on the saddle facing
forward and place the ball of your foot on the pedal at its lowest point. Your leg should
be mostly straight at this point with a slight bend at the knee. You should be able to
pedal the bike without overextending your leg when the pedal is at its lowest point. Your
legs may be overextended where it causes your hips to move side to side which means
the seat must be lowered.
● To adjust your seat up or down, unlatch the seatpost clamp. Move the seat to the
desired height and close the seatpost clamp. The open and closed positions of the
seatpost clamp are shown below (open position on left, closed position on right).
● If you need to adjust the angle of your seat, loosen the nuts on both sides of the seat,
move the seat to the desired angle, then tighten the nuts. The nut’s location is shown
below.
7
To Next Page
Loading...
Need help?
General
