Lennox SignatureStat 81M26 User Manual

What are the INSTALLER settings?
The INSTALLER SETTINGS are setup during the initial installation. They tell the thermostat how to function with your heating or
cooling equipment. The following is a brief overview and discussion of these settings.
SYSTEM SETUP
Choose the system component that the thermostat will control.
With the 81M26, either a furnace or a single-stage heat pump (with no auxiliary heat)
can be used. If FURNACE is selected, then either a GAS/OIL or ELECTRIC furnace
can be used.
1st STAGE HEATING
With the 81M27, either a GAS/OIL or ELECTRIC furnace can be used.
21
INSTALL MENU
SELECT
1ST STAGE HEATING
GAS / OIL
ELECTRIC
HOME
SELECT
INSTALLER SETTINGS
INSTALLER SETTINGS
INSTALLER SETTINGS
HOME
MAIN MENU
SELECT
SELECT
SYSTEM SETUP GAS
RESIDUAL COOL 60
LOW BALANCE 45˚F
HIGH BALANCE 95˚F
AUTOCHANGEOVER ON
EER ON
DEADBAND 3˚F
HUMIDITROL OFF
SECURITY OFF
CONTACT INFO
SERVICE INT
REMINDER RUN
INSTALLER SETTINGS
MAIN MENU
SELECT
CONTACT INFO
SERVICE INT
REMINDER RUN
TEMP OFFSET 0.0°F
* DEADBAND is displayed only
when AUTOCHANGEOVER is ON.
*
INSTALL MENU
SELECT
SYSTEM SETUP
FURNACE
HEAT PUMP
110-1052F 5/12/05 11:59 AM Page 21

Lennox SignatureStat 81M26 Specifications

General

Brand	Lennox
Model	SignatureStat 81M26
Category	Thermostat
Language	English