TS 6 to 20 Ton R−410A Air Conditioners / Page 7
Specifications 10 TON
General
Data
Model No. TSA120S4S
TSA120S4D
Nominal Size − Tons 10 10
Connections
(sweat)
Liquid line − in. (o.d) (1) 5/8 (2) 5/8
Suction line − in. (o.d) (1) 1−3/8 (2) 1−1/8
Refrigerant (R−410A) Factory installed holding charge
1
Field provided charge with 25 ft. line set 17 lbs. 0 oz. 20 lbs. 0 oz.
Condenser
Coil
Net face area − sq. ft. Outer coil 29.3 29.3
Inner coil 28.4 28.4
Tube diameter − in. & no. of rows 3/8 − 2 3/8 − 2
Fins per inch 20 20
Condenser
Fan(s)
Diameter − in. & no. of blades (2) 24 − 3 (2) 24 − 3
Motor hp (2) 1/3 (2) 1/3
Total air volume − cfm 8300 8300
Rpm 1075 1075
Watts 830 830
ELECTRICAL DATA
Line voltage data − 60 hz − 3 phase 208/230V 460V 575V 208/230V 460V 575V
2
Maximum Overcurrent Protection (amps) 70 40 25 50 25 20
3
Minimum circuit ampacity 43 24 18 41 21 15
Compressor No. of Compressors 1 1 1 2 2 2
Rated load amps (total) 30.1 16.7 12.2 18 (32) 7.8 (15.6) 5.7 (11.4)
Locked rotor amps (total) 225 114 80 110 (220) 52 (104) 38.9 (77.8)
Condenser
FanMotor
(1 phase)
No. of motors 2 2 2 2 2 2
Full load amps (total) 2.4 (4.8) 1.3 (2.6) 1 (2) 2.4 (4.8) 1.3 (2.6) 1 (2)
Locked rotor amps (total) 4.7 (9.4) 2.4 (4.8) 1.9 (3.8) 4.7 (9.4) 2.4 (4.8) 1.9 (3.8)
NOTE − Extremes of operating range are plus and minus 10% of line voltage.
1
Refer to the Lennox Refrigerant Piping Manual to determine refrigerant charge required with longer length refrigerant lines.
2
HACR type circuit breaker or fuse.
3
Refer to National or Canadian Electrical Code manual to determine wire, fuse and disconnect size requirements.