Safety information
N
EDK10200EV3 DE/EN/FR 5.0
PN
L
4. Electrical connection
The Drive PLC may only be operated with a DC voltage of +18 ... 30 V. Higher voltages, or AC voltage, will destroy
the device.
The device must not be connected to voltages > 50 V against PE.
The device must not be used in mains circuits.
The degree of insulation of the device depends on the degree of insulation of the voltage source and the
components connected.
5. Operation
Because of the variety of possible applications for the Drive PLC, special rules and regulations must be observed
by the project planner, who is also responsible for their implementation. Here are some basic rules:
z EMERGENCY-OFF devices must remain effective in all operating states of the plant or system.
z After switching on the system, no undefined or unpredictable states may arise.
z The valid safety and accident prevention regulations for the specific applications must be observed.
6. Maintenance and service
The manufacturer’s documentation must be observed.
These safety instructions must be kept!
To Next Page
Loading...
Need help?
General
