EN
6
GETTING STARTED
1. Remove all packaging.
2. Snap the two pieces of the base together.
[Figure 2.1]
3. Unscrew the plastic nut from underneath
the tower fan. [Figure 2.2]
4. Secure the base to the tower fan with the
plastic nut. [Figure 2.3]
5. Place the tower fan on a flat, stable
surface such as the floor.
6. Insert the power adapter into the port at
the bottom of the tower fan. Plug in and
turn on. [Figure 2.4]
USING YOUR TOWER FAN
Tap to cycle through fan modes: Normal,
Turbo, and Auto.
Fan Modes
• This is the tower fan’s default mode.
• will show on the display.
Normal Mode
Use Normal Mode to manually control the
tower fan’s speed. Tap to change fan
speed from 1 (low) to 12 (high).
Use Turbo Mode with air conditioning to
quickly circulate air in your home.
Turbo Mode
REMOTE CONTROL
Sound O Button
• Press to turn selection sounds
on/o.
Note:
• Remove the plastic tab from the remote
control’s battery compartment before using.
•
To replace the battery, see page 8.
The remote control can be used to control any
of the tower fan’s functions from a distance.
The remote must be within 5 m / 16 ft of the
tower fan to work.
On/O
Button
Sound O
Button
Timer
Button
Fan Mode
Button
Oscillate
Button
Advanced
Sleep
Button
Increase/
Decrease
Fan Speed
1. Plug in and tap to turn on the tower
fan.
2. Tap to change fan speed from 1 (low)
to 12 (high).
3. Move the angle adjuster up and down to
adjust the direction of the wind.
[Figure 3.1]
4. Optionally, tap to select a dierent
fan mode, or tap to turn Advanced
Sleep Mode on/o.
1. Tap and select Turbo Mode. and
will show on the display.
WARNING: Do not use the fan before finishing assembly.
To Next Page
Loading...
Need help?
General
