Lexmark MS315dn User Manual

PostScript paper tray support
When the printer receives one of the operators listed in “Tray selected with tray operators” on page 11, it performs the
actions listed in this section. This paper tray selection process ends when a suitable paper source is chosen and paper is fed
from that source.
• The printer checks the value of manualfeed in statusdict and the ManualFeed page device parameter. If either one is true,
then the printer sends a message to load the requested size in the manual feeder or multipurpose feeder.
• The PageSize Policy is set to 0 by means of setpagedevice.
• The printer checks the paper size loaded in the current active source to determine if it matches the requested size. If the
sizes match, then the paper is fed from the active source.
Note: The current active tray is the last source that was selected from the control panel or by the printer language.
• If the requested size and the size loaded in the active source do not match, then the sources are searched in the order
defined by the Priority array in the InputAttributes dictionary in the pagedevice dictionary.
• If the requested media size is not found by the previous search, then the following search order is used:
– Tray 1
– Tray 2
– Tray 3
– Multipurpose feeder
– Tray 4
• If the requested size cannot be located in any automatic source, then a configurationerror is issued and the job is flushed.
For printers that support automatic two‑sided printing (duplexing):
• All papers, except custom‑size paper and envelopes, are supported for duplexing in the multipurpose feeder.
• If the paper source is changed before the back side of a two‑sided page prints, then a blank back page prints, the paper
source changes, and the information for the back side of the page is printed on the front side of a page sent from the new
paper source.
When these operators are used, it is equivalent to executing the following PostScript emulation sequence:
<< /PageSize [x y]/ImagingBBox null /Policies << /PageSize 0>> >>
setpagedevice
where x and y are the PageSize in points.
= Supported
X = Not supported
Printer model
Operator Tray selected
(corresponding image size
is set)
MS310, MS312, MS315,
MS410, MS415, MS510,
MS610
MX310, MX410,
MX510, MX511
MX610, MX611
11x17tray Tray with 11 x 17 in.‑size
paper
XXX
a3tray Tray with A3‑size paper XXX
a4tray Tray with A4-size paper
a5tray Tray with A5-size paper
a6tray Tray with A6-size paper
b4tray Tray with B4‑size paper XXX
b5tray Tray with B5-size paper
customtray Tray with custom-size paper XXX
executivetray Tray with executive-size
paper
PostScript (PS) emulation 11

Lexmark MS315dn Specifications

General

Brand	Lexmark
Model	MS315dn
Category	All in One Printer
Language	English