To Next Page

To Previous Page

ENGLISH

Installing on a Wall

For proper ventilation, allow a clearance of 100 mm on each side and from the wall. Detailed installation instructions

are available from your dealer, see the optional Tilt Wall Mounting Bracket Installation and Setup Guide.

100 mm

To install your monitor on a wall, attach a wall mounting bracket (optional part) to the back of the monitor.

Make sure that the wall mounting bracket is securely fixed to the monitor and to the wall.

1 Use only screws and wall mounting brackets that conform to VESA standards.

2 Screws which are longer than standard length may damage the inside of the monitor.

3 A non-VESA standard screw may damage the product and cause the monitor to fall. LG Electronics is not liable for

any accidents related to the use of non-standard screws.

4 Please use VESA standard as below.

• 785 mm and above

* Fixing screws: Diameter 8.0 mm x Pitch 1.25 mm x Length 9 mm (75TC3D)

* Fixing screws: Diameter 6.0 mm x Pitch 1.0 mm x Length 12 mm (65TC3D, 55TC3D)

785 mm

CAUTION

• Disconnect the power cord before moving or installing the monitor to avoid risk of electric shock.

• If you install the monitor on a ceiling or slanted wall, it may fall and result in injury. Use an authorized LG wall mount

and contact your local dealer or qualified personnel to assist with the installation.

• Do not over tighten the screws as this may damage the monitor and void your warranty.

• Use only screws and wall mounting brackets that meet the VESA standard. Any damage or injuries caused by misuse

or use of improper accessories are not covered by the warranty.

• To prevent injury, this apparatus must be securely attached to the wall in accordance with the installation instructions.

(This pertains only to Australia and New Zealand.)

LG 55TC3D User Manual

Other manuals for LG 55TC3D