Operating20
Operating
3
Radio Operations
Be sure that FM antenna is connected.
(Refer to page 15)
Listening to the radio
1. Press FUNCTION until FM appears in the display
window.
The last received station is tuned in.
2. Auto tuning : Press TUNING -/+ on the remote
control or
Y/U
on the unit for about 2
seconds until the frequency indication starts
changing, then release. Scanning stops when
the unit tunes in a station.
Manual tuning: Press TUNING -/+ on the
remote control or
Y/U
on the unit
repeatedly.
3. Adjust the volume by pressing VOL +/- on the
remote control or by rotating volume knob on
the unit repeatedly.
Presetting the Radio Stations
You can preset 50 stations for FM.
Before tuning, make sure to turn down the volume.
1. Press FUNCTION until FM appears in the display
window.
2. Select the desired frequency by pressing
TUNING-/+ on the remote control or
Y/U
on the unit.
3. Press PROGRAM/MEMORY. A preset number
will blink in the display window.
4. Press PRESET·FOLDER
W
/
S
to select the
preset number you want.
5. Press PROGRAM/MEMORY on the remote
control. The station is stored.
6. Repeat steps 2 to 5 to store other stations.
7. To listen to a preset station, press
PRESET·FOLDER
W
/
S
or 0 to 9 numerical
buttons.
Deleting all the saved stations
1. Press and hold PROGRAM/MEMORY for two
seconds. “ERASEALL” will blink in the unit display.
2. Press PROGRAM/MEMORY to erase all saved
radio stations.
Improving poor FM reception
Press
d
/
M
on the remote control or
T
on the
unit. This will change the tuner from stereo to
mono. Then the reception will be better than
before.
CM4340P-FV.DAUSLLK_ENG_0125.indd 20 2014-03-07 1:37:53
To Next Page
Loading...
Need help?
General
