15INSTALLATION
ENGLISH
2 While supporting the door, remove the 2
screws b on the door hinge, two from each
hinge. Set the door aside face down on a
protected surface to prevent damage to the
door or the work surface.
• The edges of the door cover may be sharp. Take
care when handling, or wear gloves to avoid
injury.
3 With the door on a protected surface, remove
all screws on each side of the door and lift off
the inner door frame c using a flat blade
screwdriver. Remove the latch hook
d and
blank
e and install them on the opposite side.
4 Remove the 4 screws f securing the hinges
to the door frame. Remove the two plastic
cover caps g. Reinstall the hinges f and
cover caps g on the opposite sides from
which they were removed.
5 With the hinges and cover caps in the new
locations, remount the inner door frame onto
the outer door frame with the screws
removed in step 3 above.
• Be sure to support the weight of the door before
assembling the hinge screws.
6 Reinstall the door with the screws removed in
step 2. Install the two plastic hole caps
removed in step 1 on the opposite side.
Installing the Vent Kit
• Use long-sleeved gloves and safety glasses.
• Use a heavy metal vent.
• Do not use plastic or thin foil ducts.
• Clean old ducts before installing the appliance.
To Next Page
Loading...
Need help?
General
