HOWTO usz 31
HOW TO USE
Operafing fhe dryer
Lint Filter
CLEAN THE LINT FILTER
If the lint filter has not already been cleaned, lift out the filter and remove the lint from the last
load. This will help ensure the fastest and most efficient drying performance.
LOADTHE DRYER
Load the dryer with the wet laundry from the washer. If the load isextra large, you may need to
divide it into smaller loads for proper performance and fabric care.
TURN ON THE DRYER
Pressthe POWERbutton to turn on the dryer.The cycle LEDswill illuminate and a signal will
sound, if turned on. Referto page 10.
SELECT A CYCLE
Turn the cycle selector knob either direction until the LED for the desired cycle is on.
The preset temperature, dry level, and option settings for that cycle will be shown. Refer to page
32. Default settings for the selected cycle can now be changed if desired. This can be done using
the cycle modifier buttons as shown on page 34. Cycle options can be added using the option
buttons as shown on page 34.
BEGIN CYCLE
Press the START/PAUSE button to begin the cycle. The cycle can be paused at any time either by
opening the door or by pressing the START/PAUSE button. If the cycle is not restarted within 4
minutes, the dryer will shut off and the cycle settings will be lost.
ENDOF CYCLE
When the cycle is finished, the chime will sound if it is set. Remove your clothing from the dryer
immediately to reduce wrinkling. If WRINKLE CARE is selected, the dryer will tumble briefly every
few minutes to help prevent wrinkles from setting in the clothes.
To Next Page
Loading...
Need help?
General
