Use an adjustable wrench to turn the leveling
feet. Turn clockwise to raise the dryer or
counterclockwise to lower it. Raise or lower
the leveling feet until dryer is level from
side to side and front to back.
Make sure that all 4 leveling feet are in firm
contact with the floor.
2
Position the dryer in the final location. Place
a level across the top of the dryer.
1
Level
Leveling Feet
LEVELING THE DRYER
CLEARANCES (cont.)
IMPORTANT:If you are installing your dryer using an optional pedestal base or stacking kit,
please refer to Optional Accessories in this manual or to the instructions for your pedestal or
stacking kit before proceeding with the installation.
For cabinet installation, with a door, minimum ventilation openings in the top of the cabinet
are required.
*Required spacing
**For side or bottom venting, 2” (5.1 cm)
spacing is allowed.
Recommended installation spacing for cabinet installation
•Allfour leveling feet must restsolidly on the
floor. Gently push on the top corners of the
dryer to make sure that the dryer does not
rock from corner to corner.
To ensure that the dryer provides optimal drying
performance, it must be level. To minimize
vibration, noise, and unwanted movement, the
floor must be a level, solid surface.
NOTE: Adjust the leveling feet only as far as
necessary to level the dryer. Extending the
leveling feet more than necessary can cause
the dryer to vibrate.
WARNING
To reduce the risk of personal injury, adhere to all industry recommended safety procedures
including the use of long sleeved gloves and safety glasses. Failure to follow all of the safety warnings in this
manual could result in property damage, personal injury or death.
w
To Next Page
Loading...
Need help?
General
