8
ENG
ENGLISH
ASSEMBLING AND PREPARING
Using the Kensington security system
The Kensington security system connector is
located at the back of the Monitor. For more
information of installation and using, refer to the
manual supplied with the Kensington security
system or visit
http://www.kensington.com
.
Connect the Kensington security system cable
between the Monitor and a table.
The Kensington security system is optional.
You can obtain it from most electronics stores.
NOTE
Detaching the Stand Base and the
Stand Body
1
Place the Monitor with the screen side down on
a flat and cushioned surface.
2
Using a coin, turn the screw in the Stand Base
counterclockwise. Detach the Stand Base from
the Stand Body.
3
Remove the 2 screws and detach the Stand
Body from the monitor.
To Next Page
Loading...
Need help?
General
